As already presented in the guide "How to check if a load cell is working correctly - Test with digital multimeter", accuracy is one of the most important characteristics of a load cell.

Malfunctioning and faults can occur within a weighing system, so having the chance to promptly locate the issue is fundamental.
To check that everything is working properly, we can take advantage of the various diagnostic features on LAUMAS weight transmitters and indicators connected to load cells.

What can be monitored through the diagnostic function, either by the instruments or remotely via PLC?
First of all it is necessary to distinguish between the features in the single-channel and multichannel instruments.

▷ SINGLE-CHANNEL INSTRUMENT BUILT-IN DIAGNOSTICS

▷ MULTICHANNEL INSTRUMENT BUILT-IN DIAGNOSTICS

Single-channel instruments are structured so that the converter inside reads just one input channel; the measured data therefore refer to a single sensor.
By connecting the load cell to the single-channel instrument, the latter is able to correctly detect faults on the connection between the single load cell and the data instrument.

In the case of multiple load cells connected in parallel to the single-channel instrument, the diagnostic function will lose precision: the single-channel instrument is in fact able to detect malfunctioning of the weighing system, but not to signal which specific load cell has the fault.
It is also possible that, due to the parallel connections to a single reading channel, the instrument might not signal some faults.

On single-channel instruments, in the "TEST" menu item, you can also see the value of the voltage in real time, that is the measurement in mV of the signal that the instrument identifies in input while it is in operation.
This is very useful in order to measure abnormal values that could not mean that the load cell is not working properly.

Monitoring the state of the connection for each single channel and detecting malfunctioning, errors and faults

1 - Automatic search.

When this function is active, each time the instrument is switched on it automatically scans each single channel and identifies which channels each load cell is actually connected to, using only the active ones to calculate the weight.

In the "CALIB" menu, select "SEL CH" and press ENTER.
The transmitter display will show the actual number of connected load cells.
If the number matches, press ENTER again to save your selection and make it permanent.

Once the setting has been saved, should an error occur on one of the connected load cells, the display will show ERCEL followed by a number identifying the exact position of the damaged load cell.

Measuring and monitoring the weight distribution on the calibration zero and on values other than zero

This functions are in the "TEST" menu under the specific item "DIAG".

Thanks to this function the user can at any time view and check how the weight on the scale is being distributed on the various load cells and how this distribution changes by modifying the weight or the position of the objects.

Weight distribution in percentage on active channels

By using this information it is possible to detect some abnormal conditions both when monitoring zero and when monitoring values other than zero.

MONITORING THE WEIGHT DISTRIBUTION ON THE CALIBRATION ZERO

The system saves how the weight is distributed on the various load cells when the scale is on zero, that is when the system is unloaded.

After unloading the scale, it is possible to enable zero diagnostics: in the DIAG menu simply set AUT 0 onto YES and press ENTER.

During system operation, if the weight distribution at zero deviates from the saved value, the instrument will show the error message ERDIAG.

It is possible to set the same type of alarm also for load values other than zero. This function is called "load diagnostics".

It is useful in order to identify mechanical problems in systems where the distribution of the load inside the container is always the same, as for example happens with liquids.
Normally, liquids occupy all the space inside their container

Recording events

The last 50 events recorded by the system are saved under DIS EV in the EVENT menu.

Recording events provides data and additional information concerning: errors on the weight, calibrations made and equalizations performed.

It is very useful above all for technical support provider.
In the event of an error occurring and it not being possible to identify its origin, this information can be used to quickly locate and resolve the issue.