Ver. 1.18.00 (25 Nov 2024)

Added

• Firmware version compliant with INMETRO regulation
• Modbus protocol: address 0 supported for broadcast communication
• RS485 serial port: continuous transmission YHL protocol available

Ver. 1.17.01 (26 Jun 2024)

Fixed

• At start up the stop bit is set to 0

Ver. 1.17.00 (24 Oct 2023)

Fixed

• The display of gross weight in net weight does not work.
• Status register: bit 15 acts as the heartbit. This bit indicates - by switching - that the internal communication between the fieldbus section and the main microcontroller is OK.

Ver. 1.16.05 (22 May 2023)

Fixed

• Modified one of the voltage thresholds used by diagnostic functions, to avoid load cell error condition incorrect signalings

Ver. 1.16.04 (18 Apr 2023)

Fixed

• The reset procedure was changed because after resetting the instrument to the factory defaults, the weight was not calculated correctly.

Ver. 1.16.03 (03 Dec 2022)

Fixed

• Threshold for load cell error alarm modified, to avoid wrong signallings
• ASCII protocol: fixed semiautomatic zero and semiautomatic tare commands working

Ver. 1.16.00 (26 Jan 2022)

Added

• NTEP compliant firmware version

Fixed

• ASCII protocol: NET command not working in case of NOT LEGAL program

Ver. 1.15.03 (28 Oct 2020)

Fixed

• ProfinetIO: exchanged gross weight assumes meaningless values, occasionally

Ver. 1.15.02 (21 Oct 2020)

Fixed

• Communication errors, in case of MODBUS reading if more than 10 registers are required

Ver. 1.15.00 (22 Sep 2020)

Added

• Real calibration, checks executed when a new calibration point is defined:
  • Real calibration, command code 106: a new calibration point is added
  • Operation not executed if the sample weight is equal to 0
  • Operation not executed if the sample weight is used in one of the currently defined calibration points

Changed

• Real calibration, command code 101 original functioning restored. It deletes all previously registered calibration points and add a new one

Fixed

• Relay outputs status, cyclically exchanged on fieldbus: also if the relays are maintained correctly closed, it shows glitches, when a low digital filter level is set

Ver. 1.14.16 (06 Jun 2020)

Changed:

• Ethernet/IP: 1.4 version of EDS file requested
• Relay outputs: maintained open during the instrument startup procedure

Ver. 1.14.14 (06 Feb 2020)

‫Internal changes without any impact on the user

Ver. 1.14.13 (11 Jan 2020)

‫Internal changes without any impact on the user

Ver. 1.14.12 (24 Dec 2019)

‫Internal changes without any impact on the user

Ver. 1.14.11 (29 Nov 2019)

Added

• First firmare release compliant with Instrument Manager service software

Changed

• Ethernet/IP: EDS file vresion 1.3 requested