Ver. 1.18.00 (25 Nov 2024)

Added

• Firmware version compliant with INMETRO regulation
• Modbus protocol: address 0 supported for broadcast communication
• RS485 serial port: continuous transmission YHL protocol available

Ver. 1.17.01 (26 Jun 2024)

Fixed

• At start up the stop bit is set to 0

Ver. 1.17.00 (24 Oct 2023)

Fixed

• The display of gross weight in net weight does not work.
• Status register: bit 15 acts as the heartbit. This bit indicates - by switching - that the internal communication between the fieldbus section and the main microcontroller is OK.

Ver. 1.16.05 (22 May 2023)

Fixed

• Modified one of the voltage thresholds used by diagnostic functions, to avoid load cell error condition incorrect signalings

Ver. 1.16.04 (18 Apr 2023)

Fixed

• The reset procedure was changed because after resetting the instrument to the factory defaults, the weight was not calculated correctly.

Ver. 1.16.03 (03 Dec 2022)

Fixed

• Threshold for load cell error alarm modified, to avoid wrong signallings
• ASCII protocol: fixed semiautomatic zero and semiautomatic tare commands working

Ver. 1.16.00 (26 Jan 2022)

Added

• NTEP compliant firmware version

Fixed

• ASCII protocol: NET command not working in case of NOT LEGAL program

Ver. 1.15.03 (28 Oct 2020)

Fixed

• ProfinetIO: exchanged gross weight assumes meaningless values, occasionally

Ver. 1.15.02 (21 Oct 2020)

Fixed

• Communication errors, in case of MODBUS reading if more than 10 registers are required

Ver. 1.15.00 (22 Sep 2020)

Added

• Real calibration, checks executed when a new calibration point is defined:
  • Real calibration, command code 106: a new calibration point is added
  • Operation not executed if the sample weight is equal to 0
  • Operation not executed if the sample weight is used in one of the currently defined calibration points

Changed

• Real calibration, command code 101 original functioning restored. It deletes all previously registered calibration points and add a new one

Fixed

• Relay outputs status, cyclically exchanged on fieldbus: also if the relays are maintained correctly closed, it shows glitches, when a low digital filter level is set

Ver. 1.14.16 (06 Jun 2020)

Changed:

• Ethernet/IP: 1.4 version of EDS file requested
• Relay outputs: maintained open during the instrument startup procedure

Ver. 1.14.14 (06 Feb 2020)

Internal changes without any impact on the user

Ver. 1.14.13 (11 Jan 2020)

Internal changes without any impact on the user

Ver. 1.14.12 (24 Dec 2019)

Internal changes without any impact on the user

Ver. 1.14.11 (29 Nov 2019)

Added

• First firmare release compliant with Instrument Manager service software

Changed

• Ethernet/IP: EDS file vresion 1.3 requested